Usb block erupter driver8/5/2023 Need to experiment with a good queue setting to control how much work BFGMiner Timeout/clock/reg_data combinations, however!Īdditionally, since the controllers are underpowered for these devices, you may You can probably use either one, but the 350 MHz clock performsīetter than the 200 MHz clock. Notice how there are duplicate settings for timeout, clock, reg_data, and NOTE: These are NOT valid BFGMiner options! "bitmain-voltage" in the /config/nf file. You want to lookĪt the "bitmain-options" from the command line, and the "bitmain-freq" and Time, but can be determined from the stock cgminer's options. The meaning of each of these options are not documented individually at this Note that reg_data is optional for S4 and S5 and will be calculated from clock set btm:clock=350 -set btm:reg_data=0d82 -set btm:voltage=x0725 S bitmain:auto -set btm:model=S5 -set btm:layout=32:8 -set btm:timeout=3 None of the device attributes are autodetectedĪt this time, so you must also tell BFGMiner this at runtime with a series of WhenĬonfiguring, use the -enable-bitmain option to build the 'bitmain' driver used Series (both USB and blades), a large variety of Bitfury-based miners,īitmain's Antminer S5 and U1-3, Butterfly Labs' SC range of devices, HashBusterīoards, GekkoScience's Compac USB stick, Klondike modules, and KnCMiner'sīFGMiner must be compiled for and run on the embedded controller. Currently supported ASIC devices include Avalon, Bitfountain's Block Erupter
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |